Role Overview
Electrical Engineering Intern owning real hardware end to end for optical communication terminals, from power and analog design to validated hardware.
Responsibilities
- Design power circuits: DC-DC converters, LDOs, load switches, eFuses, current sensing, protection, rail sequencing.
- Design analog circuits: op-amp signal conditioning, amplifiers, filters, references, current/voltage sources, ADC/DAC front ends.
- Simulate in LTspice and check against bench measurements.
- Lay out PCBs in Altium or KiCad with grounding, thermal, decoupling design.
- Assemble and bring up boards, hand soldering, staged power-up, fault isolation.
- Write embedded C on STM32 for ADC, DAC, PWM, timers, GPIO, UART/I2C/SPI.
- Debug with oscilloscope and logic analyser; use SWD.
- Validate against specs: efficiency, ripple, regulation, protection, noise, thermal.
- Build test setups and run EMI/EMC checks; document designs and results.
Requirements
- Pursuing or recently completed B.Tech/M.Tech in Electrical, Electronics, ECE, or Instrumentation Engineering.
- Real hands-on hardware: designed, built, debugged boards yourself.
- Analog fundamentals: op-amps, filters, references, current sensing, ADC/DAC resolution.
- Power fundamentals: linear vs switching regulators, topologies, inductor/capacitor selection, ripple, efficiency, thermal, protection.
- PCB design: at least two boards through schematic, layout, fabrication, bring-up.
- Embedded C on STM32 or similar: configure peripherals, read datasheets, debug on target.
- Bench skills: hand soldering, fine-pitch SMD, rework, oscilloscope, DMM, bench supply.
- Tools: LTspice/Ngspice, Altium/KiCad, Embedded C/C/C++, STM32CubeIDE/GCC, ST-Link/J-Link.
- Analysis/version control: Python or MATLAB, Git.
- Awareness of IPC standards, derating, EMI/EMC, safety.
- Clear communication, honest reporting, fast learning.
Nice to Have
- Experience on a student engineering team: rocketry, SAE BAJA, Formula Student.